don't know about 95 gen2

I have done this before on previous non-bull car
& I think I did have the headliner out on my gen3 but don't remember why

so these are generic instructions:

1.) remove plastic moulding all around from a - b - c pillars
may involve un-bolting seatbelts @ the sliding shoulder attachments


2.) remove dome light & sun shields

3.) remove headliner from car

4.) remove fabric from cardboard & scrape off decaying foam from cardboard
try to get as much off as possible (important to get a good glue bond)

5.) for glue I used home depot / paint department / quart can of contact cement

6.) I don't think I re-used the original fabric but don't remember

might have just gone to a fabric store & looked for 2x2 yards of something close

need to use your best judgement

hope this gives you some ideas

-

have also done leather work on my gen3 seat
but this is a much more involved project

if your serious about this
my advice is to go look for a usable temporary seat at a JY
while you are re-building your original

took me months for the full tear down & rebuild / hand re-stitch

for me it was easier to bond fresh leather hidden on the back of the panels
rough side -on- rough side with silicone RTV & stitch the 2 together
than to try & find a color match.

I still use them in the house on stands -
never did let the JY take my Gen3 front seats

 

I wasn't going to try the seat repair, just the h/l. (An upholstery shop would patch the leather panel after I take the seat out).
I have no problem with the car being out of commision while the seat is out - I have other cars to pick from.

Dropping the h/l is something I think I can do, but I'm hoping for pointers on how to remove what I understand will be a delicate board from the car without folding or breaking it after I drop it.