Taurus Car Club of America : Ford Taurus Forum banner
1 - 2 of 2 Posts

·
Premium Member
Joined
·
14,127 Posts
Installation

1. Clean the gasket surfaces on the cylinder block and oil pan.

2. Note: Prior to applying sealer, clean sealing surface with Metal Surface Cleaner F4AZ-19A536-RA or equivalent meeting Ford specification WSE-M5B392-A, to remove all residues that may interfere with the sealer's ability to adhere.

Note: When using silicone sealer, assembly should occur within seven minutes after sealer application. After this time, the sealer may start to set-up, and its sealing effectiveness may be reduced.

Apply a 6 mm (1/4-inch) bead of Silicone Gasket and Sealant F7AZ-19554-EA or equivalent meeting Ford specification WSK-M2G343-A4 to the junction of the rear crankshaft main bearing cap and cylinder block and junction of the engine front cover and cylinder block.

3. Locate oil pan gasket to oil pan with sealing bends against oil pan surface and secure with Gasket and Trim Adhesive F3AZ-19B508-AA or equivalent meeting Ford specification ESE-M2G52-A.

4. Position oil pan.

5. Install oil pan retaining bolts. Tighten to 10-14 Nm (89-123 lb-in).

6. Back off all bolts and retighten.
 

·
Premium Member
Joined
·
14,127 Posts
Apply a 6 mm (1/4-inch) bead of Silicone Gasket.... to the junction of the rear crankshaft main bearing cap and cylinder block and junction of the engine front cover and cylinder block.

Looks like at the front and rear of the pan where the crank exits.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top