Taurus Car Club of America : Ford Taurus Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
7 Posts
Discussion Starter · #1 ·
I am making a 3D model of the Vulcan engine. I am trying to figure out the distance between the bores, which is listed as 4.33''. This seems a little extreme. This wouldn't happen to be the distance from the center of one bore to another, would it?
 

·
Registered
Joined
·
198 Posts
I am making a 3D model of the Vulcan engine. I am trying to figure out the distance between the bores, which is listed as 4.33''. This seems a little extreme. This wouldn't happen to be the distance from the center of one bore to another, would it?
sound about right. (size of bore)
 
1 - 3 of 3 Posts
Top