Taurus Car Club of America : Ford Taurus Forum banner

1 - 7 of 7 Posts

·
Registered
Joined
·
19 Posts
Discussion Starter · #1 ·
I'm looking for the voltage reads and order of the pin outs on both the DPFE and MAF sensor connectors . Its for a 2000 Taurus SE with 3.0 2v. Think I might have some broken wires in the harness cause already had to splice one wire and now its throwing P0140 and the running rich codes for both banks. It's stumbling and misfiring real bad plus running rich as a pig leaving huge soot deposits. Thanks for any help.
 

·
Premium Member
Joined
·
14,126 Posts
The voltage in is 5v. Voltage out is variable depending on flow and ranges from about 0.5V to 4.5V.
 

·
Registered
Joined
·
19 Posts
Discussion Starter · #3 ·
Awsome, thanks for the reply. You wouldn't happen to know the pin position for the voltage in would you.
 

·
Premium Member
Joined
·
14,126 Posts
The 2000 Ford CD sucks.

The DPFE only has three wires. One is ground, one is 5v and one is the sensor output.

The MAF is here.
 

Attachments

1 - 7 of 7 Posts
Top