[gtx2000]

Well i went over this taurus over and over but everyone i talk to says i got one. BUT how do i find it there is only 4 ports on the intake manifold and are easily traced one is the source for the Misc items such as the cruise and booster, the other is for the PCV, another one for the fuel pressure regulator, and one for the map sensor. i got new seals on the injectors and i've installed millions of injectors i hear no hiss i got the upper and lower intake gaskets replaced i've tried carb cleaner but the searching idle and stalling is still there?

 

[medicTA]

Have you tried propane?
Remember to check all hoses by bending and flexing them and the brake booster as well.

 

[tflander2003]

clean the idle air sensor/ thingie on top of the motor then reset the computer by taking the cable off the battery for 20 mins or more

 

[sundarpn]

wats the best way to secure the hoses. Is there somethin like a teflon tape or (plumbers tape) that I can wrap on before sliding the hoses on. to make the fittings leak proof.

 

[medicTA]

Any good hardware store will have small hose clamps, if you are confident the hose in question has at least a little slack you can cut an inch off the end of it to sometimes get a tighter fit.
Have you tried cleaning the IAC?

 

[gtx2000]

Yea I got a new IAC from napa and even exchanged it for a new one jic it was faulty. I dropped off the car at my local diagnose center tongiht hopefully i get an answer tomorrow.