Taurus Car Club of America : Ford Taurus Forum banner

1 - 6 of 6 Posts

·
Premium Member
Joined
·
1,322 Posts
Discussion Starter #1
Is there an underdrive pulley ( or set of pulleys ) that will work with the 3.0L Duratec Taurus (2001). I'm taking out my system so I figured now it is feasable, thanks for any information.
 
J

·
Guest
Joined
·
0 Posts
I'm pretty sure Venom has an UDP on his 99 Duratec, might want to ask him.
 

·
Premium Member
Joined
·
1,322 Posts
Discussion Starter #5
Well IF I can find some used ones which ones am I looking for? The one for the SVT Contour duratec. Or for the 96-99 SHO Yamaha engine? Anywhere that would make these custom? Anyone know which size would be appropriate? (And how the heck would I find a belt that would fit the new ones?) Again thanks for any help!
 

·
Premium Member
Joined
·
2,415 Posts
I've been talking with a guy via email and we're supposed to meet up sometime this week so I can give him my stock crank pulley along with some measurements from my sho shop udp so he can make a udp. Not sure if he wants to start manufacturing and distributing udp's, but I can ask him about it.

And you can technically use the stock size belt with the udp, BUT I went to a smaller belt because my belt was slipping during the hard shifts because of my chip. I went with a gatorback 4060735. Stock size is 4060747.
 
1 - 6 of 6 Posts
Top