Taurus Car Club of America : Ford Taurus Forum banner

1 - 7 of 7 Posts

·
Registered
Joined
·
512 Posts
Discussion Starter #1
i'm trying to remove my y-pipe and just wondering which penitrating spay everyone uses and which one works the best. i've tried the 2 bolts that connect the y-pipe to the rest of the exhaust and they are not going to budging and i'm going to have to get the stripped bolt removers for those since they are rounded off. i just want to know so when i try to get the other ones out.
 

·
Premium Member
Joined
·
1,654 Posts
I always use PB Blaster. It has always worked for me by loading it on, covering the bolt for a few days before you want to take it apart and sometimes a little heat helps it work better. So far thats the best one I have used. :thumb:
 

·
Premium Member
Joined
·
2,073 Posts
I just heated mine up till it was red hot with a blowtorch and turned it fast.
 

·
Premium Member
Joined
·
7,306 Posts
WD40 or PBBlaster.

If it's real bad, heat it up with a torch then let it cool down a bit and try to remove.
 

·
Premium Member
Joined
·
15,578 Posts
CRC 6-56 > *.*.

You will not find a better lubricant available for automotive use. Buy the marine grade stuff. It's even better than the automotive grade.

JR
 

·
Registered
Joined
·
512 Posts
Discussion Starter #7
CRC 6-56 > *.*.

You will not find a better lubricant available for automotive use. Buy the marine grade stuff. It's even better than the automotive grade.

JR
[/b]
were do they sell that at?
 
1 - 7 of 7 Posts
Top