Taurus Car Club of America : Ford Taurus Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
Hi guys.I searched and couldnt find any answers so im helping if there is already a thread somebody can help me.I have to drive to my dads Tomorrow and replace his front motor mount on his "92 3.0.I have done many on other cars but never a Taurus.Is is just the typical raise the engine a bit and swap them out or is there more involved?I found a writeup on the 3.8 but to my understanding the 3.0 is a bit different.Any help would be appreciated.
 

·
Registered
Joined
·
65 Posts
Yes that's pretty much it. I break loose the top bolt through the block bracket then break loose and remove the nut off the bottom stud through the frame. Then I put a short piece of 2x4 wood under front of oil pan and lift with a floor jack. Raise it until the mount starts rising off frame then remove the bolt through the block bracket. May have to raise engine a little more to get the mount out and new one in. Reverse the order for reassembly.
 
1 - 2 of 2 Posts
Top