Taurus Car Club of America : Ford Taurus Forum banner

Removing Strut from Steering Knuckle - Question

10048 Views 7 Replies 4 Participants Last post by  JW657
I am in the process of installing new front struts. I've removed the pincher bolt and the bolt from the sway bar endlink. I tried to beat the knuckle off the end of the strut. I made some heady way but probably have another .5" to go. I can beat the thing down some more but dont want to damage anything. Any suggestions or do I need to remove another bar? Its an 02 sable. I've been following this guys guide on youtube and everything was going fine until the 3:20 mark.

Thanks in advance.
1 - 1 of 8 Posts
If only auto zone rented out a 300+ lb guy I might be able to do this.
I'm a small guy, I usually do pretty good on my own since I have lots of tools and breaker bars. It sucks to be small sometimes though :(
1 - 1 of 8 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.