Taurus Car Club of America : Ford Taurus Forum banner

1 - 16 of 16 Posts

·
Registered
Joined
·
23 Posts
Discussion Starter #1
hi, noobie here with a Taurus X, will the mustang PBR calipers bolt onto the Gen 5 spindles?
 

·
Registered
Joined
·
23 Posts
Discussion Starter #3
well then, I guess I'll have to figure it out and post my results,
 

·
Premium Member
Joined
·
8,708 Posts
From the looks of them, the g5's already look to have dual-pot calipers up front. A closer inspection may be required.
 

·
Premium Member
Joined
·
2,492 Posts
I know of guy with a set he'd offer cheap to try. With PFC pads and all... ;)
 

·
Registered
Joined
·
23 Posts
Discussion Starter #9
^^^^^^^^^ more info please^^^^^^^^
 

·
Premium Member
Joined
·
2,492 Posts

·
Registered
Joined
·
35 Posts
The part numbers listed on Autozone for stock GT calipers vs stock '08 calipers is close, but still different. They look very similar, but I don't know what the difference is.

While on this brake topic... has anyone tried slotted/drilled Mustang rotors on their '08+?
 

·
Registered
Joined
·
35 Posts
FYI - I went to the Autozone website for the purpose of comparing part numbers and found that the rotors and pads are the same for the '08 Taurus and the '08 Mustang GT. This is good news despite the fact that the calipers might be different.
 

·
Registered
Joined
·
27 Posts
Slightly off topic er generation, but what about retrofitting 2009 or 10 brakes to earlier generations?? Anyone looked at that yet???
 
1 - 16 of 16 Posts
Top