Taurus Car Club of America : Ford Taurus Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
10 Posts
Discussion Starter · #1 ·
hey folks,

I've been doing a little maintenance on my 96 the past few weeks while i've had the money and extra time. I started off Just looking to replace the left strut mount....then noticed the inner cv boot was shot. Now I've gotten a good look at my engine mount on the left side, and the thing is shot completely to hell and back. So I got out my trusty cherry picker , lifted the engine up just enough to yank it out of there..yea shot.

So my question is, anyone have any suggestions if I should try to replace the other side as well? The other side LOOKS ok, but I know i've read that it's suggested to always do both as a general rule. Let me know what yall think-

J
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top