Taurus Car Club of America : Ford Taurus Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
16 Posts
Discussion Starter · #1 ·
i have a 95 taurus 3.0 se and i took off the stock air filter and made a custom intake by cutting the square part of the piece thats the maf bolts to and i connected the maf part to the throttle body and then the pipe and filter and the car would not start took out the maf sensor and the car ran fine with the check engine light on so today i got a new maf from the junkyard and it starts but stalls out after a few seconds and i disconnected it and it runs ok but sometimes stalls out when im at a stop but starts right up anyone have any idea i need to fix this i use my car everyday
 
1 - 1 of 1 Posts
Top