Taurus Car Club of America : Ford Taurus Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
1,770 Posts
Discussion Starter · #1 ·
I am thinking of converting my front gen 3 brakes to 11.6 inch rotors. I will get a new rotor and pads for this. If I do it, after this conversion I will end up with my old front rotors, the pads, and caliper brakets. Those old rotors and pads still look o.k. (pads have more than 50% of material on them after driving 30,000 miles).

Is it possible to reuse these parts somehow when converting the rear drum brakes to a disk setup? The stock 96-99 rear disks look kind of wimpy.
 
1 - 3 of 3 Posts
Top