Taurus Car Club of America : Ford Taurus Forum banner
1 - 3 of 3 Posts
G

·
Discussion Starter · #1 ·
I think these could be made from some salvaged tails, some PVC pipe, and some elbow grease. This is a rough picture I sketched on Photosuite (although i am not an artist
) Would this be feasible?





The original pictures were taken from the TCCA garage, as I didn't have shots of Taurus readily available.
 
G

·
Discussion Starter · #3 ·
The look I was going for is like that of the newer Altimas, where there is a cylinder with a red lens on the end.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top