Taurus Car Club of America : Ford Taurus Forum banner
1 - 1 of 1 Posts

· Registered
215 Posts
Most connectors have built-in clips on the side(s). I often use a small screwdriver to help me pry the clip away from the connector a little bit so as to unhook it and allow for the connector ends to pull apart.

Some other connectors, however, require pressing in a little "latch" that is also a part of the connector itself, before it will slide part.
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.