Taurus Car Club of America : Ford Taurus Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
23 Posts
Discussion Starter · #1 ·
Hey guys, I am new to the taurus mods and I have a question.
I bought one of those MAF resistors that you put in the IAT sensor and have been running with it for a couple weeks now. When I start my car and toss it in to reverse (say if I am in a hurry) my tori will stall. If i rev the engine a little bit, the car pushes out some gray/blue exhaust and is fine after. I only started noticing this post install of the resistor. I have noticed some pickup difference, but I dont know if it is worth the chance of damage to the car.
Any suggestions?

Also, I just got a MAF adapter and a 6" Kool blue cone
, and it is rockin. Great mod.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top