Taurus Car Club of America : Ford Taurus Forum banner
1 - 1 of 1 Posts

·
Premium Member
Joined
·
2,282 Posts
Originally posted by fojt19@Feb 28 2004, 06:35 PM
Where is there a hole in the gen 4 firewall i need to run wire for driving lights. Or where can i drill one?
On the right hand side of the engine bay there is a gromet on the firewall with nothing going into it..


you will need to PULL it out, or push it through and pick it up in the drivers side footwell... be careful, because it can get stuck inside of the car, and you wil have to dig it out from the inside...

once ya get it out, put a small hole in it, and pop it back in.. it wot fit as tight whne you put it back in, but you can manage...

Hope this helps!

Jesse
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top