Taurus Car Club of America : Ford Taurus Forum banner

Firewall Question

1192 Views 2 Replies 3 Participants Last post by  SHO 2NV
Basically, my question is how to get through the firewall without drilling a new hole in it? I'm in the process of putting on an underbody kit and need to get through the firewall to run my switch...but I can't seem to find an opening either inside the car or in the engine compartment. Anyone know?
1 - 3 of 3 Posts
Originally posted by hoolaking@Apr 10 2004, 05:08 PM
Basically, my question is how to get through the firewall without drilling a new hole in it? I'm in the process of putting on an underbody kit and need to get through the firewall to run my switch...but I can't seem to find an opening either inside the car or in the engine compartment. Anyone know?
There's a large harness that runs into the passenger compartment on the driver's side, just above the brake booster (I think). Drill a hole in the grommet for that harness (from the inside out, unless you like splicing wires all night), and run the wires there. That's where I'll be running my siren and hood switch wires.
Drill a hole....no harm; no foul. Just make sure you seal it up properly.

My .02
See less See more
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top