Taurus Car Club of America : Ford Taurus Forum banner
1 - 5 of 5 Posts

·
Registered
Joined
·
671 Posts
Discussion Starter · #1 ·
I have a '97 vulcan. When it goes under the knife again this spring/summer, it's getting G4 exhaust manifolds and a shiny new y-pipe. I know that G4 and G3 y-pipes end in different spots, so I'll need to grab a G4 exhaust pipe. Would a G4 'tec exhaust bolt up to the same spot, or is it a continuation of the G3 design? Also, did G4 'tecs come with dual exhaust?
 

·
Registered
Joined
·
671 Posts
Discussion Starter · #3 ·
I know that probe guys use G4 front manifolds as headers. I assumed that if they'd improve the front manifold, then the rear manifold would be better as well. With the different manifolds comes the different y-pipe.
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top