Taurus Car Club of America : Ford Taurus Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter · #1 ·
I have a 2001 ford Taurus v-6 OHV engine. I replaced the engine and now I can't seam to keep the Cam Position Sensor code (If I remember right, the code is P1309) from coming on. I clear the code than I drive the car a few miles and then the engine light and code return. I have tried disconecting the battery after I have cleared the code but I get the same results. The car runs great even with the engine light on. I have tried resetting the cam position sensor, I have even purchased a new sensor and installed the new sensor, same results.

Does anyone have any information for me that might help.:angry:
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top