Duratec Performance High Flow Y-pipe

3069 Views 24 Replies 8 Participants Last post by J Rod, Dec 29, 2003

J Rod

Discussion Starter · Dec 18, 2003

The Y-pipe does fit, I know it is amazing. Considering the fact that I had problems too. At first I thought the flex pipe flange was warped (becasue it would not seal and it sounded like i had no exhaust) so i got a hold of Nick and he sent me another, well it was doing the same thing it turned out the be that I had the wrong size gasket, I then got one from autozone and viola it was sealed and I had some trouble with the 02 sensor holes but i end up going back to the original Y-pipe that he had sent me and it works perfectally with the new gasket.

Well fear not duratec owners me a nick are working on a revised y-pipe. I am sending him my stock y-pipe so that he will have it to take meausurements. Hopefully it will work out and we wont have so much difference between pipes built of the same jig.

Jarod Adams

Save

1 - 2 of 25 Posts

theman21

· #19 · Dec 24, 2003

I blame myself for some of the mishap. As you know I was the donor for the first y-pipe and I did the first prototype. there was some modifications that were needed after the first one was made, but unfortunatly I became busy and I didn't have the time to drop my y-pipe again and try to fit again. I know nick was under pressure to get these things out so my bad

. After hearing that some of the people were having problems with the fitings I am hoping we can get this resolved by getting a better fitting and hopefully some highflow cats too.
here are some pics when I put the first prototype on.