Taurus Car Club of America : Ford Taurus Forum banner
1 - 1 of 1 Posts

· Premium Member
Joined
·
1,004 Posts
+1, Yes. The ball joints are pressed-out and then pressed in. This can be done at home with the right ball joint tools. I believe OTC or K-D tools make a front-end or ball joint tool kits for this. OTC and/or K-D tools may be found at Sears? Not sure.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top