Taurus Car Club of America : Ford Taurus Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
I've had to replace the bearings, so while I had the front end apart, I took a look at the lower control arms and discovered the ball joints were on their way out. Purchased new Moog parts and got the passenger side installed - no problem.

The driver side, however, has me stumped. I undid the tension strut as per the manual, got the control arm seated on the other end of the strut and the head of the control arm placed back between the tabs on the frame. The problem is that the hole in the tab on the frame closer to the front of the vehicle will not line up with the bolt hole in the bushing.

Is there a trick I am missing to get the frame bolt installed so I can button this car back up?

Thanks in advance...
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top