Taurus Car Club of America : Ford Taurus Forum banner

1 - 1 of 1 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter · #1 ·
hello, i just replaced both CV/axles in my brothers 1990 ford Taurus station wagon,3.0,automatic trans,. i did one side at a time. 1st the drivers side then passenger. ok, the drivers side went pretty smooth no issues, the passengers side took a little effort removing the old axle. i reinstalled both axles.. until i couldn't push/press it in . put everything back together took it for test run everything was fine then ,no drive/reverse,etc.luckily i wasnt far and was able to tow it back to house. any suggestions as to what i did wrong? if the axles have to seat farther into trans what is best way to this? i am going to look at it tomorrow evening. thanks in advance..
 
1 - 1 of 1 Posts
Top