Taurus Car Club of America : Ford Taurus Forum banner

Search results

1-20 of 122 Results
Advanced Search
  1. Climate control Taurus PI

    5th and 6th Gen Maintenance and Repair
    Probably your HVAC control module. Just have to pull the sync screen and it sits behind there. Not a bad job.. if it were me, I’d buy a low mileage used one from ebay or a salvage yard and replace it. Sent from my iPhone using Tapatalk
  2. Hard start after Taurus sits overnight (2013 SEL)

    5th-6th Gen Electronics, Security, Audio, Visual
    This ended up being diagnosed as a bad mass air flow sensor. I replaced it and the hard starting (long cranking, sputtering) is gone. FYI, in case someone else experiences this later..
  3. 11 Taurus Back-Up Camera working intermittently

    5th and 6th Gen Maintenance and Repair
    The camera will need replaced. It’s not hard. Pull carpet from deck lid and change out camera from behind the emblem housing. They get intermittent before they die.
  4. 11 Taurus Back-Up Camera working intermittently

    5th and 6th Gen Maintenance and Repair
    If you know how to use OBD-II : FORScan, look for a diagnostic trouble codes (DTCs) in the park aid module. It can help you pinpoint the issue - a sensor or the wiring circuit.. if it’s not just a sensor, then you may want to look for any damage in the wires (driver side, pull the carpet back in...
  5. 2013 Taurus SE fuse question - gear indicator and steering wheel buttons illumination

    Maintenance and Repair
    On another note, you'll want to move this post to 5-6th Gen, since it's a 2013 Taurus.
  6. 2013 Taurus SE fuse question - gear indicator and steering wheel buttons illumination

    Maintenance and Repair
    fperezal - If I had to guess, I'd start with Fuse #12. See the attached pics, and let us know if that works for you. I know what you mean - I've been on my back changing fuses in this panel, and it's not the best, especially sliding out of the there then standing up. You're not the only one...
  7. Hard start after Taurus sits overnight (2013 SEL)

    5th-6th Gen Electronics, Security, Audio, Visual
    How do I check fuel PSI in FORScan? Sent from my iPhone using Tapatalk
  8. Hard start after Taurus sits overnight (2013 SEL)

    5th-6th Gen Electronics, Security, Audio, Visual
    Thanks. I replaced the entire throttle body. Is the IAC something different? I also did the MAF spray on the MAF wires. Still hard starts when cold.. any other ideas? I don’t see any diagnostic trouble codes and there is no check engine light, which surprises me.. I want to get to the bottom of...
  9. Hard start after Taurus sits overnight (2013 SEL)

    5th-6th Gen Electronics, Security, Audio, Visual
    Hi Dundun - good thoughts, thanks. I cleaned the MAF recently, and yes, the TB came new with the senator attached, I believe. I’m really hoping this isn’t the fuel pump, b/c I believe it’s integral to the fuel tank... I haven’t done that kind of DIY work before (other than fuel filters on older...
  10. Sub install

    5th-6th Gen Electronics, Security, Audio, Visual
    I had Best Buy put a Kicker system into my 2013 Taurus SEL. They pulled up a spec sheet for the Taurus that told them which two wire colors to tap into behind the screen to get their right/left audio outputs to the amp. Don’t try tapping into rear speakers, the sound quality will suffer. The...
  11. Warning about Sync Update (V3.10) for Sync 2 MFT!

    5th-6th Gen Electronics, Security, Audio, Visual
    Interesting, for future reference, how would you go about installing a single, missing app? Sent from my iPhone using Tapatalk
  12. 2013 heated seat not working

    5th and 6th Gen Maintenance and Repair
    Lol! So there is a filter on a 2013 with just heated (not cooled) seats? If so, I need to figure how to access it.. I’m all about preventive maintenance but didn’t know about the seat filter. And here I was all proud of myself b/c I change the HVAC filter behind the glovebox 3X/year... I know a...
  13. Warning about Sync Update (V3.10) for Sync 2 MFT!

    5th-6th Gen Electronics, Security, Audio, Visual
    Hopefully, nothing else is missing... Sent from my iPhone using Tapatalk
  14. Warning about Sync Update (V3.10) for Sync 2 MFT!

    5th-6th Gen Electronics, Security, Audio, Visual
    Wow, it’s good to know what happened. How did you figure that out? Sent from my iPhone using Tapatalk
  15. Warning about Sync Update (V3.10) for Sync 2 MFT!

    5th-6th Gen Electronics, Security, Audio, Visual
    Here ya go. 2 attachments b/c it’s too long for one. Let me know what you see, thanks. Sent from my iPhone using Tapatalk
  16. Warning about Sync Update (V3.10) for Sync 2 MFT!

    5th-6th Gen Electronics, Security, Audio, Visual
    So as an update, the dealership put the 911 assist app back on using IDS. I’m glad it’s not an issue across the board. I’m curious why my v3.10 update removed just that app, but may never know. Back in business now though. I didn’t see any beneficial changes to the update from 3.8 to 3.10...
  17. Warning about Sync Update (V3.10) for Sync 2 MFT!

    5th-6th Gen Electronics, Security, Audio, Visual
    Thanks for letting me know, Dundun. That confirms there is something wrong with mine. Ford customer care called today, and said that the “911 Assist application” will need added back into my sync software separately using IDS at the dealership. That appt is Weds. fingers crossed.. if that...
  18. FORScan | How to Modify/Program Module Data

    5th and 6th Gen Maintenance and Repair
    So you were able to keep a “5” / heavy steering and get rid of the light by clearing DTCs? Sent from my iPhone using Tapatalk
  19. 2013 heated seat not working

    5th and 6th Gen Maintenance and Repair
    Where is the filter? I thought that was only on the cooled seats because they have a fan. Correct me if I’m wrong. Sent from my iPhone using Tapatalk
  20. Ambient lighting issue?

    5th-6th Gen Aesthetics, Interior, Wheels, Tires
    Mine doesn't work either - just some colors work, and the slider for dimming doesn't...
1-20 of 122 Results
Top