All mods have been put on hold for now. I'm just maintaining my car until May, when I finish school... but will probably have a little time in between papers and tests to drop in and see what mods folks are up to. If you've done something to your bull, post it here so we can know what you've...

Okay, folks, so rather than have eleventy-billion threads of off topic stuff, I present one post where we can put them all. (obviously, we'll still have individual posts.) But there are some things that aren't worth a full post, and we can post them here and discuss. My hope is that this...

<div align="center">STEP-BY-STEP REPLACEMENT OF REAR STRUT ASSEMBLIES As I promised a few weeks ago, here are my step-by-step procedures for replacing the rear strut assemblies on a GenIV Taurus Sedan. I would rate the project as a competent beginner to intermediate level job and anyone with...

02' 3.0 Vulcan While performing the Clinton flush, i found a loose ground wire on the passenger side near the firewall. I have yet to purchase a book for this car so im hoping someone can tell me where it goes. I tried to follow the natural bend of the wire to locate it but no luck. Also...

Hello all! So I personally get asked a lot about how to program modules in the Taurus as well as what programs are needed to do this, required hardware, emotional reassurance, etc. In a nutshell, there unfortunately is extremely minimal material available for the Taurus (and I'm sure we all...